Filter
Top Products
BASICS [ 15]
BASICS
Adjusting the Handset Ringer and Earpiece Volume
Ringer tone and volume
When the phone is in standby mode, pressing the vol ▼ or ▲ key on the handset selects the handset ringer
volume and tone. There are two ringer tones each with two volume levels. Continue pressing the
vol ▼ or ▲
key to listen to all tone and volume levels. The phone keeps the last ringer tone and volume setting selected.
Earpiece volume
The handset earpiece volume settings (Low, Medium, High and Maximum) can only be
adjusted during a call. Press
vol ▼ or ▲ to select Low, Medium, High and Maximum.
When you hang up, the phone keeps the last volume setting selected.
Talk 0:15
Volume High
Redial
The redial/p key redials the last number dialed. The redialed number can be up to 32 digits long.
Tone Dialing Switch-over
Some telephone companies use equipment that require pulse dialing (sometimes
referred to as rotary dialing). If you need to enter tone dialing digits, you can
switch-over to tone dialing during the call. An example of this could be entering
your bank account number after you have called your bank. The digits of your bank
account can be sent using DTMF tones.
Initially make your call with the pulse dialing mode. Once your call connects, press
*/tone . Enter the
desired number (like in example above the bank account number). These digits will be sent as tone
dialing. This special number can be stored in a memory location and used for Chain Dialing
(See page 20.) Once the call ends, the tone mode is canceled and pulse dialing mode resumes.
The tone feature
only applies when
the dial mode is
set to pulse.
2960_eng combined.qxd 1/22/01 11:50 AM Page 15