Filter
Top Products
GETTING STARTED [ 9]
D. Choose the dialing mode
Most phone systems use tone dialing which sends DTMF tones through the phone lines. However some
phone systems still use pulse dialing such as in rural areas. The default setting is tone dialing.
Depending on your dialing system, set the mode as follows:
1)Press and hold
flash until you hear a confirmation tone.
The current setting appears next to Dial Mode.
2)To set the dial mode for pulse dialing, press
#
.
Or to set the dial mode for tone dialing, press
*
/tone . A confirmation
tone sounds to indicate the setting is complete.
•If you are not sure of your dialing system, set for tone dialing. Make a trial call. If the call connects,
leave the setting as is, otherwise set for pulse dialing.
•If your phone system requires pulse dialing and you need to send the DTMF tones for certain situations
during a call, you may “switch-over” to tone dialing. (Refer to “Tone Dialing Switch-over” on page 15.)
Dial Mode:Tone
Tone - Press *
Pulse - Press #
Make sure your
battery pack is
fully charged
before choosing
the dial mode.
GETTING STARTED
2960_eng combined.qxd 1/22/01 11:50 AM Page 9