Filter
Top Products
GETTING STARTED[ 8 ]
Place the power
cord so that it
does not create a
trip hazard or
where it could
become chafed
and create a fire
or electrical
hazard.
2)Set the base on a desk or tabletop, and place the handset on the base unit as
shown. Remove the beltclip, if attached, for face up charging. (See "Mounting
the Base Unit on a Wall", on page 11.)
3)Then raise the antenna to a vertical position.
4)Make sure that the
status LED lights. If the LED does not light, check to see
that the AC adapter is plugged in and that the handset makes good contact
with the base charging contacts.
•Use only the supplied AD-310 AC adapter. Do not use any other AC adapter.
•Connect the AC adapter to a continuous power supply.
•Place the base unit close to the AC outlet so that you can unplug the AC adapter easily.
• The handset
can be placed
up or face
down in the
base for
charging.
• You have to
remove the
beltclip, if
attached for
face up
charging.
5)Connect the telephone line cord to the TEL LINE jack and to a
telephone outlet once the handset is fully charged.
If your telephone outlet isn't modular, contact your
telephone company for assistance.
Modular
• After installing the battery pack in the handset, charge your handset at least
15-20 hours before plugging into the phone line. Once the handset battery
pack is fully charged, connect the telephone line cord to the base and
telephone wall outlet.
2960_eng combined.qxd 1/22/01 11:50 AM Page 8