Filter
Top Products
Note:
If the REC TIME/ANN/4/1 switch is set to Announce Only, then the preset message “Hello. No
one is available to take your call” is played.
3. To select your recorded message again, press
ogm
.
The preset message will begin to play on the Base Unit
speaker.
4. While the preset message is playing, press
ogm
again.
A tone will sound, and your recorded message will play on the Base Unit speaker. A second tone
sounds after your message plays, and the Answering System automatically returns to Standby.
VOX/Calling Party Control Feature
The Calling Party Control (
CPC
) feature allows your Answering System to disconnect and reset if the caller
hangs up before leaving a message. This prevents your Answering System from using recording time to record
a hang up/dial tone message.
Setting the Toll Saver Switch
The Ring Time/Toll Saver switch allows you to set the number of rings the caller hears before your Answering
System answers. You can set the switch to answer after 2 rings or after 4 rings. In the TS (Toll Saver) position,
the Answering System answers after two rings if you have new messages recorded, and it answers after four
rings if there are no new messages. So if you call long distance to check your messages, you can hang up
after the second ring and not be billed.
Using the Reset Button
The RESET button is used to erase all recorded outgoing messages and any messages which are saved in
memory. Pressing RESET does not erase your
PIN
(Personal Identification Number) code or the security code
between the Handset and Base Unit.
45