Filter
Top Products
If the Battery icon begins to flash, the phone is programmed to eliminate its functions to save power. The table
below describes what to do to return your phone to normal operation.
DURING A CALL IN STANDBY MODE
Only the
Abutton operates.
None of the buttons will operate.
The Handset beeps and the battery icon flashes
once every 3 seconds.
The Handset beeps and the battery icon flashes
once every 3 seconds.
Complete your call as quickly as possible. You will not be able to make a call.
Return the Handset to the Base Unit for charging. Return the Handset to the Base Unit for charging.
Note: Allow 15 to 20 hours without any interruption for the Handset to fully recharge.
Battery Memory Effect
Rechargeable batteries can develop a “memory” (reduced charge capacity) caused by repeated charge and
discharge cycles. The battery life will seem to be shorter every time you use the unit.
To Avoid Memory Effect
At least once a month, operate the unit until the “Battery Low” indicator appears. Avoid “topping off” the charge
after using the phone for a short time. Also, do not charge the Rechargeable Battery for extended periods of
time.
Setting the Pulse/Tone Switch
Be sure the
PULSE/TONE
switch is in the
TONE
position.
Note: Most phone systems are Tone dialing. Check with your local phone company if you are not sure
whether your system is Tone or Pulse dialing.
23