Filter
Top Products
27
Setting up the Phonebook
Your phone allows you to store up to 100 names in your handset and base phonebook. Your phone shares
memory between your phonebook and CID with a total of 100 entries. Once you store 100 phonebook entries, CID
information will not be stored and will only display at time of new incoming calls. When Phonebook entries are full,
you will hear a beep and MEMORY FULL appears. You cannot store additional names and numbers unless you
delete some of the existing ones.
You can also use the Phonebook or speed dial locations to store a group of numbers (up to 20 digits) that you may
need to enter once your call connects. This is referred to as Chain Dialing. See Chain Dialing from the Phonebook
on page 36.
Creating Phonebook Entries
To store names and numbers in your Phonebook, please follow these steps:
When the phone is in standby mode, press [ ] (on the left side of the four-way
key).
To create a new phonebook entry, press the STORE soft key. STORE/EDIT
NAME appears.
Enter the name for this entry (Edit Name).
Use the keypad to enter a name for this entry; the name can contain up to 16
characters. (See page 13 for instructions on entering text.) If you do not want to
enter a name for this entry, your phone will store this entry as No Name. Press
the OK soft key when you are nished.
1)
2)
3)
2JQPGDQQM
5GCTEJ=#<
㨲㨱
?
5VQTG=5614'?
$#%- %12; 5614'
2JQPGDQQM
5GCTEJ=#<
㨲㨱
?
5VQTG=5614'?
$#%- %12; 5614'
5VQTG'FKV0COG
/QXKGU
㨫
$#%- &'.'6' 1-
5VQTG'FKV0COG
/QXKGU
㨫
$#%- &'.'6' 1-