Filter
Top Products
Setting the Number of Rings
The ring time setting allows you to set the number of rings the caller hears before your answering system plays the
outgoing message. You can set the ring time to answer after six, nine or twelve rings. If you enable the Toll Saver
(TS) setting, the answering system picks up after two rings if you have new messages, and after four rings if there
are none. This way, if you make a long distance call to check your messages, you can hang up after the second
ring to avoid long distance billing charges.
From the base
[menu/clock]
[ /select] [ /select]
[set]
[menu/clear]
[select/ ]
1. Press three times. The base
displays the current number of rings (6, 9, 12, or
TS for toll saver) and announces the setting.
2. Press or until the
desired ring time appears.
3. Press .A confirmation tone sounds, and the
system announces the new ring time.
1. Press . Select the ANSW.
SETUP menu, and then the RING TIME
submenu.
2. Move the cursor to select a ring time (TOLL
SAVER, 6 TIMES, 9 TIMES, or 12 TIMES).
3. Press . You will hear a
confirmation tone.
From the handset
[46]