Filter
Top Products
10
To switch to all capital letters, press
*
.
The phone defaults to all
capital letters first (e. g. ABCabc2) until you enter a blank space or
press
*
again. (Any time you want to change case, just press
*
.)
If two letters in a row use the same number key, enter the first letter
and wait a few seconds (or press
RighT
); the cursor will move to the
next space. Enter the next letter.
Press
#
to enter a blank space.
To change a letter, move the cursor to that letter and press
ClEaR
to
erase the letter. Then, enter the new one.
To erase the entire entry, press and hold
ClEaR
.
Press
0
to cycle through all available symbols and punctuation.
Basics
To... Earpiece
make a call: Dial the
number, then
Press
Talk/Flash
. Press
spEakER
.
answer a call Press
Talk/Flash
. Press
spEakER
.
hang up Press
End
or put the handset in the cradle.
switch between the
speaker & earpiece
Press
spEakER
.
mute the microphone
during a call
Press
mEssagEs/mUTE
. Press again to turn
the microphone back on.
put a call on hold
Press
ClEaR/inTERCom
. After 5 minutes on
hold, the call will be disconnected.
return to a call on hold Press
Talk/Flash
. Press
spEakER
.
mute the ringer for this
call only
While the phone is ringing, press
mEssagEs/
mUTE
.
Changing the Volume
You can set speaker volume levels separately for the base and each
handset. You can also set the earpiece volume on each handset.
Anytime you are listening to a speaker or earpiece, press
Up
to
increase the volume and
down
to decrease it.