Filter
Top Products
English - 17
may not cause harmful interference, and (2)
This device must accept any interference
received, including interference that may
cause undesired operation. Privacy of
communications may not be ensured when
using this phone.
FCC PART 15.105(b): Note: This
equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there
is no guarantee that interference will not
occur in a particular installation. If this
equipment does cause harmful interference
to radio or television reception, which can
be determined by turning the equipment
off and on, the user is encouraged to try to
correct the interference by one or more of
the following measures:
x Reorient or relocate the receiving antenna.
x Increase the separation between the
equipment and receiver.
x Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
x Consult the dealer or an experienced radio/
TV technician for help.
RF Exposure Informaon
This product complies with FCC radiation
exposure limits under the following
conditions:
x The base must be placed to allow a
minimum of 20 cm (8 inches) between the
antenna and all persons during normal
operation.
x The base must not be collocated or operated
in conjunction with any other antenna or
transmitter.
x The handset is designed for body-worn
operation and meets FCC RF exposure
guidelines when used with any belt clip,
carrying case, or other accessory supplied
with this product. (All necessary accessories
are included in the package; any additional
or optional accessories are not required
for compliance with the guidelines.) Third
party accessories (unless approved by the
manufacturer) should be avoided as these
might not comply with FCC RF exposure
guidelines.
Disable All Funcons Except
Charging
D1484 Base
1. Press and hold
skIp
and
VoL +
simultaneously, then plug in the AC
adapter.
2. Continue to hold the keys for about 5
seconds. When the message counter
turns off, all functions are disabled
except for charging.
D1484 Handset
1. Install the battery.
2. When the “Welcome, please wait...”
message disappears from the display,
press and hold
ENd
,
MENu
, and
*
simultaneously.
3. After about 5 seconds, a confirmation
tone sounds, indication all functions
except charging are disabled.
To return to normal operation, cycle
the power for the base and remove and
reinstall the handset battery.
Industry Canada (I.C.) Noce
Terminal equipment
NOTICE: This equipment meets the
applicable Industry Canada Terminal
Equipment Technical Specifications. This
is confirmed by the registration number.
The abbreviation IC before the registration
number signifies that registration was
performed based on a Declaration of
Conformity indicating that Industry Canada
technical specifications were met. It does
not imply that Industry Canada approved
the equipment.
NOTICE: The Ringer Equivalence Number
(REN) for this terminal equipment is
marked on the equipment itself. The REN
assigned to each terminal equipment
provides an indication of the maximum