Filter
Top Products
Reversing the Handset Retainer
1. Removethe Handset Retainer from the Base
Unit by sliding it upward.
2. Flip the Retainer over so the tab is facing up.
3. Slide the retainer back into the Base Unit.
NOTE: If you put the Retainer back into the
Base Unit incorrectly, it will jam, and you'll
need to pry it up with a screwdriver.
Connecting the AC Power
Connect the AC power to the unit by plugging the
AC adaptor into the back of the Base Unit, and
into a standard 230/240 VAC wall outlet. Make
sure to route the adaptor cord where it will not
create a trip hazard, or where it will not become
chafed and create fire or other electrical hazards.
Connecting the Telephone Line
Plugone end of the Telephone Line Cord into the
back of the Base Unit, and the other end into a
standard modular telephone socket.
Installing the Handset Antenna
Screw the flexible antenna into the top of the
Handset.
Installing the Battery Pack
1. Remove the battery compart-
ment cover on the rear of the
Handset by sliding it down.
2. Connect the Ni-Cd (Nickel
Cadmium) battery pack by
plugging it into the socket at
the top of the batterycompart-
ment.
Note: The connector will fit
only one way, and will require
only a minimal amount of
pressure to insert. The battery
cable plug must a~waysbe
installed with the red lead up.
- 10-
~ ----
- --
=
=
IIIklm