45
7. If you selected ED-SCT in Step 3, stop here.
Otherwise, if you selected ED-HI or ED-LO in Step 3, follow these steps to enter the
talk group ID (agency, fleet, and subfleet) for the system you want to scan.
a. Press DATA.
b. If necessary, turn the rotary tuner or repeatedly press HOLD U or LIMIT V until
PRO9 ID appears. Then press E on the keypad.
c. Turn the rotary tuner or repeatedly press HOLD U or LIMIT V until the talk group ID
memory location where you want to store an ID appears.
d. Use the keypad to enter the agency, fleet, and subfleet, then press E. (Press
. to
enter the hyphen).
e. To enter additional IDs, repeat Steps c-d.
Programming LTR Systems
1. Hold down TRUNK for about 2 seconds. The scanner beeps and BANK, TRUNK, and
the bank letters A-J blink.
2. Press a bank key to select the bank where you want to store the frequencies.
3. Select LTR scanning by turning the rotary tuner or repeatedly pressing HOLD U or
LIMIT V to select LT. Then press E on the keypad.
4. If necessary, repeatedly press HOLD U or LIMIT V
until PRO9 F appears. Then press
E on the keypad.
5. To enter trunking frequencies, use the keypad to enter the first frequency, then press E
on the keypad. (Press
. to enter the decimal point).
Note: To clear a mistake while entering a frequency, press
. twice then enter the
frequency again.
6. For each additional frequency, select the next channel by turning the rotary tuner or
pressing HOLD U. Then use the keypad to enter the next frequency, then press E on
the keypad. (Press
. to enter the decimal point).
7. Follow these steps to enter the talk group ID (agency, fleet, and subfleet) for the system
you want to scan.
a. Press DATA.
b. If necessary, turn the rotary tuner or repeatedly press HOLD U or LIMIT V until
PRO9 ID appears. Then press E on the keypad.
c. Turn the rotary tuner or repeatedly press HOLD U or LIMIT V until the talk group ID
memory location where you want to store an ID appears.
d. Use the keypad to enter the agency, fleet, and subfleet, then press E. (Press
. to
enter the hyphen).
e. To enter additional IDs, repeat Steps c-d.