Uniden 9035 Telephone User Manual


 
49
50
Using the Answering
System
To operate from a remote location, use any touch-tone telephone, and follow these steps:
Call your telephone number and wait for the system to answer. If the answering system is off, it will answer after
about fteen rings and sounds a series of beeps.
During the greeting or the beeps (if answering system is off), press [#] and enter your security code/PIN within
two seconds.
The answering system announces the current time and the number of messages stored in memory.
You hear “To play incoming messages, press pound-two. For help, press pound-zero” followed by a beep.
Enter a remote command from the chart below. You have fteen seconds to enter the rst command; after the
rst command, you have two seconds to enter each command.
If you want to Press If you want to Press
Play incoming
messages
[#] then [2]
The answering system plays back
messages for four minutes, then
waits for another command. To
continue playing your messages,
press [#] then [2] again.
Stop the current operation to
enter a different command.
[#] then [5]
Repeat this message
[#] then [1] (after the rst four
seconds of this message)
Turn the answering system off [#] then [9]
Go back to the
previous message
[#] then [1] during the rst four
seconds of a message
Turn the answering system on [#] then [6]
Skip this message [#] then [3] Listen to the help prompts [#] then [0]
Delete this message [#] then [4] Exit the system Hang up.
When you nish, you will hear intermittent beeps indicating that the system is in the command waiting mode.
Enter another command from the chart within fteen seconds.
Hang up to exit the system. The answering system automatically returns to its normal standby setting.
1.
2.
3.
4.
5.
6.
DECT ELITE OM.indb 50 13/3/08 4:16:50 PM