Filter
Top Products
33
REMOTE OPERATION
REMOTE OPERATION
REMOTE OPERATION
You can operate the DTAM from any remote location using a
touch-tone phone, or from a rotary phone using a pocket tone-
dialler.
Call your telephone
When you hear the OGM, enter your security code. After a long
beep, enter your remote command code(s).
If you do not hear an OGM, the unit is either in Answer-off mode
or is not setup properly.
Remote Answer-on
• Call your telephone (After 15 rings you will hear
"Answer Off")
• Enter your remote security code within 8 seconds.
(The DTAM beeps to confirm valid code)
• Enter 0 1 for OGM1 or 0 2 for OGM2 (Announce only)
• The DTAM announces "Answer On’,
Then plays your selected OGM.
NOTE: • An outgoing message must be recorded before you can remotely
set the DTAM to answer calls.
• If you do not enter each digit of the security code within 8 seconds,
the DTAM hangs up. If the DTAM is set to answer-on, it answers
according to the number of rings you set. The DTAM plays OGM1.