Uniden 7000A Answering Machine User Manual


 
19
PREPARATION
PREPARATION
SETTING THE DAY AND TIME
The DTAM records the day and time of the call with each phone message.
Follow these steps to set the current day and time.
1. Press and hold down
time set
button until the DTAM announces
the day of the week.
Release the
time set button.
2. Press or until
the DTAM announces the desired
day of the week.
3. Press
time set The DTAM announces the preset hour.
4. Press or until the DTAM announces the desired
hour.
5. Press
time set The DTAM announces the preset minute.
6. Hold down or until the DTAM announces the
desired minute.
7. Press
time set to confirm the settings, appears.
The DTAM announces the day and time then beeps. disappears.
To check the current day/time at any time, press
time set
NOTE:
Adjust Volume Slider on the right side of the DTAM to the
desired listening level.
If you do not complete each step within 8 seconds, the
DTAM sounds four beeps, you must then start again from Step 1.
To avoid having to reset the time if AC power is lost, we
recommend you install a backup battery before you set the
day and time.