Filter
Top Products
CALLER ID [47]
www.uniden.com
Using the Caller ID Message List
Calling a party from the Caller ID list
From Standby mode
1) When the phone is in standby mode, view the Caller ID
message (see "Viewing the Caller ID List" on page 45).
2) Press
talk/flash
or
speaker
. The displayed phone number
dials automatically.
From Talk mode
1) Press
talk/flash
or
speaker
.
2) View the Caller ID message you want to dial (see "Viewing the Caller ID List" on page 45).
3) Press
select/
. The displayed phone number will be dialed.
Long Distance calls and Area Code Setting/Cancellation
While the present Caller ID information is displayed, pressing
*
/tone/
←
will place or
remove the prefix "1" in the display to set the call for a long distance call, or pressing
#/
→
will set or cancel an area code (see page 25).
Storing Caller ID messages in the Phonebook
Messages shown in the Caller ID list can be stored in the phonebook. The phone number and
name of the party on the Caller ID list can be stored in memory.
1) When the phone is in standby mode, view the Caller ID message to be stored.
Then press
select/
.
Store/Edit Name
appears.
2) To complete the setting, follow the steps 4-8 in "Storing Phone Numbers, Names,
Distinctive Rings, and Speed dial" on page 36.
#/
,CPG5OKVJ
•You cannot make a call
from the Caller ID list if
your phone is connected
to a private branch
exchange (PBX).
•When a long distance call
has been set,
1
appears in
the display.
•If a call comes in via a
telephone system that
does not offer Caller ID
service, no information
is stored.
•If the Caller ID message
was received as a private/
unknown number, or the
message does not have
the number, you cannot
store the message in the
Phonebook. If it was
received as private/
unknown name, the
message will be stored as
<No Name>.
•Even if the 100 memory
locations are full, the
message will be stored in
the Phonebook. However,
the message will be
erased from the Caller
ID list.
note
CALLER ID