Filter
Top Products
[32] BASICS
www.uniden.com
Mute Microphone
You can temporarily turn off the microphone so that the person you are talking with cannot
hear you.
1)Press
menu/del
during talk mode (while phone is in use).
2)Press
ring/vol/
∧
or
ring/vol/
∨
to move the pointer to
Mute
and then
select/
.
Mute On
and appear in the display. To cancel muting, repeat above step again when Mute
is set to on,
Mute Off
appears.
Tone Dialing Switch-over
Some telephone companies use equipment that requires pulse
dialing (sometimes referred to as rotary dialing). If you need
to enter tone dialing digits, you can switch-over to tone
dialing during the call. This feature is useful when you need
tone dialing to use automated systems, for example, entering
your bank account number after you have called your bank.
Initially make your call with the pulse dialing mode. Once your
call connects, press
*
/tone/
←
. Enter the desired number.
These digits will be sent as tone dialing. Once the call ends,
the tone mode is canceled and pulse dialing mode resumes.
Traveling Out-of-Range
During a call, as you begin to move your handset too far from your base unit, noise may
increase. If you pass the range limits of the base unit, you will hear a beep and see
Out of
Range
on the display, and then the handset returns to standby mode. You may return to the
call if you move your handset within the range limits of the base and press
talk/flash
or
speaker
within 30 seconds.
ߦ
•The tone feature only
applies when the dial
mode is set to pulse.
•This special number
can be stored in a
memory location. This
is referred to as Chain
Dialing (see page 43).
note
BASICS