Filter
Top Products
IPT1020-SD Settings
Initializing the IPT1020-SD
94 Strata CTX DKT/IPT Telephone 10/03
Initializing the IPT1020-SD
CAUTION! If you initialize the IP telephone, all settings return to default.
1. Press
++++ROG (simultaneously).
2. Press
9RO ▲.
3. Press
)% to initialize the telephone’s function settings (LED On = initialize,
LED Off = don’t initialize). See “IPT1020-SD Function Settings” on page 97 for
details.
4. Press
)% to initialize LCD contrast setting (LED On = initialize, LED OFF =
don’t initialize).
5. Press
)% to initialize the telephone’s IP network connection settings (LED On =
initialize, LED Off = don’t initialize). See “IPT-to-IP Network Connection
Instructions” below for details.
6. Press
+ROG again to complete the initialization process.
7. Go off-hook and hang up.
IPT-to-IP Network Connection Instructions
1. Press ++++ROG (simultaneously).
2. Press
, then press +ROGto select the Network Setting Mode.
3. Press
)% to see if the DHCP server is in use or not. Press one of the following
(normally, use
: manual setting):
: manual setting, then press +ROG.
: auto setting by DHCP server, then press +ROG.
4. Press
)%. Enter the IP address for this IPT and press +ROG. To enter the period in
an IP address, press the
button on your dialpad (e.g., if the IP address is
“192.168.1.241,” press
).
5. Press
)%. Enter the subnet mask number and press +ROG. (e.g., if the subnet
mask address is “255.255.255.0, press
).