Filter
Top Products
WARRANTY/SERVICE
33
Additional Information
PROBLEM
The answering
machine does not
answer the call.
Aanswering machine
does not play.
The messages are not
recorded/incomplete.
The answering
machine does not
respond to remote
operation.
The LED display shows
"A"
(Announce only)
.
Can not delete
messages.
SOLUTION
• The recording capacity is full.
→ Delete the unnecessary message.
• No message is recorded.
→ This is normal.
• The message was too long or too short.
→ The message should not be longer than the recording
time (1 or 4 minutes), or shorter than 2 seconds.
• The recording capacity became full.
→ Delete recorded messages.
• The phone was answered during recording.
• The recording time is set to A (announce only).
→ Set the REC TIME to 1 or 4 minute setting.
• You are not calling from a touch tone phone.
→ Call from a touch tone phone.
• The security code (PIN) you entered was wrong.
→ Make sure you entered the correct security code (PIN).
→ If the answering machine is turned off, the phone will
answer and the greeting message will be played after 10
rings. After you hear several short beeps, enter and
your security code (PIN).
•
This is normal. The recording time is set to A (announce only).
→ Set the REC TIME to 1 or 4 minute setting.
• There is a message has not been played.
→ Play the new message then delete message.
#
FT-8901.qx 1/5/1 11:29 AM Page 33