Filter
Top Products
16
BASIC OPERATION
REDIAL
OUT OF RANGE
During a call, as you begin to move too far from the base unit, the
noise increases. Then, you should move close to the base unit. If you
travel out-of-range, your call terminates.(See page 17 “Interference or
static”)
CALL WAITING
To use this feature, you must subscribe to the Call Waiting Service.
1 When you hear a call-waiting tone during your conversation on the
phone, simply press .
2 To return to the first caller, press again.
NOTE:
Pressing without receiving a Call Waiting signal may disconnect the
current caller.
HANDSET EARPIECE VOLUME SETTING
To adjust the earpiece volume, press during a call.
HANDSET RINGER VOLUME SETTING
To adjust the ringer volume, press during standby mode.
NOTE:
When the handset is on the base, the handset ringer volume is disabled
.
VOL/RING
VOL/RING
FLASH
FLASH
FLASH
Basics
Handset On The Base
1) Pick up the handset and press .
2) Listen for the dial tone.
3) Press .
RDL/P
TALK
Handset Off The Base
1) Press .
2) Listen for the dial tone.
3) Press .
RDL/P
TALK
FT-8901.qx 1/5/1 11:28 AM Page 16