Filter
Top Products
WWW.TALKSWITCH.COM 5
TS-200 USER GUIDE
Installing headsets with RJ22 connectors
Note: In order to use a headset with an RJ22 connector, you will need an external
controller/amplifier to switch between handset and headset.
1. Connect your headset to the phone.
• Disconnect the handset from the handset jack on the left of the phone.
• Plug your headset controller into the handset jack.
• Plug the handset into the headset controller.
2. Configure the phone for headset mode.
• Press the button located at the upper right side of the phone.
• Press the key for HEADSET
• Press the softkey.
• Press the softkey to turn headset mode on.
• Press the softkey.
• Press and hold the button to exit the option menus.
Installing headsets with 2.5mm connectors
1. Plug your headset into the 2.5mm jack
located on the right side of the phone.
2. The phone will automatically detect
the headset and enable headset mode.
Using headsets with the TS-200
Once headset mode is enabled, you can make and receive calls using the headset
without having to lift the handset.
The function of the button changes once a headset is installed:
• Pressing the button once places the phone off-hook for
making or receiving calls with the headset.
• Pressing the button a second time engages the speakerphone
instead of the headset.
• Pressing the button a third time disconnects the call.
• Pressing the button at any time will also disconnect the call.
SETTING THE DATE AND TIME
Date and time is automatically set when the phone receives its first phone call.
It will use the time and date from Caller ID to synchronize itself with the
TalkSwitch date and time.
RELEASE
SPEAKER
SPEAKER
SPEAKER
SPEAKER
RELEASE
SAVE
CHNG
SELECT
3
OPTIONS
2.5 mm Headset Jack