Filter
Top Products
8
Preparation
1
Lift the handset, then press
PHONE
and listen for the dial tone.
2
Press any number other than
0
.
Note:
If your phone system requires that you dial an access code (9, for example) before you dial an out-
side number, do not press the access code either.
If the dial tone stops, you have touch-tone service. Since the phone is preset to touch-tone service, you do
not to make any change to the dialing mode.
If the dial tone continues, you have pulse service. Press
PHONE
PROG/MEM
#
#
#
3
.
If your phone is set for pulse service and you want to change the dialing mode to touch-tone service, press
PHONE
PROG/MEM
#
#
#
8
.
SETTING THE DAY AND TIME
You can use the handset as well as the keys on the base to operate the TAD. To use the handset, simply press
ANS SYS
to access the TAD before beginning each procedure. The ANS SYS indicator lights and the TAD an-
nounces the number of messages then beeps twice.
Follow these steps to set the day and time so the TAD can record the correct information when each message
and memo is received.
Note
: If you do not complete each step within 20 seconds, the TAD sounds two beeps and exits setup. Start
again at Step 1.
1
Press
CHANGE
then
CLOCK
. A number from
1
–
7
(the day of the
week, with
1
being Sunday) appears on the message counter window
and the TAD announces the currently set day.
Note:
The TAD’s message counter window might also alternately show other information to tell you the status
of the TAD.
2
Press
REPEAT/SCAN
or
SKIP/SCAN
as instructed by the voice
prompts.
3
When you complete setting the day and time, the TAD announces the day and time then beeps twice.
To check the current day/time at any time, press
CLOCK
.
ANNOUNCEMENT OPTIONS
Before using the SP-515, you can record an announcement (up to three minutes long) that callers hear when
the system answers a call.
If you do not record a personalized outgoing message, the TAD plays
Hello. Please leave a message after the
tone
.
Illustration of handset
illustration of
base front
illustration of
base front