Filter
Top Products
11
Telephone Operation
n
Telephone Operation
MAKING AND RECEIVING A CALL
To make a call, lift the handset and press
PHONE
. When the
PHONE indi-
cator lights steadily and you hear the dial tone, dial a phone number or
memory number (see “Memory Dialing” on Page 13).
To answer a call if the handset is on the base, simply lift the handset and begin your conversation. Or, if the
handset is away from the base, press
PHONE
first. The PHONE indicator on the handset and the IN USE indi-
cator on the base light.
Note: If
RINGER
is set to
OFF
, you must press
PHONE
to answer a call.
To end a call, place the handset on the base or press
PHONE
The indicator turns off.
Notes
:
²
If you press
PHONE
to hang up and the phone does not disconnect, move closer to the base then press
PHONE
again, or place the handset on the base.
²
If you want to make a call but the handset is out of the base’s range, the handset beeps twice. Move the
handset closer to the base and try again.
SETTING THE HANDSET’S VOLUME
You can select any of three volume levels by repeatedly pressing
VOL-
UME
during a call. Three short beeps sound when the handset is at the
highest setting. If you press VOLUME again, the handset returns to the
lowest setting.
CHANGING THE CHANNEL
The SP-515 scans 25 channels (frequency pairs used between the base and the handset) and automatically
selects a clear channel each time you make or receive a call.
If you hear other conversations or excessive noise during a call, press
CHANNEL
on the handset to select a different channel.
Note: If the handset is too far from the base, the channel might not change. Move closer to the base and try
again.
USING REDIAL
You can quickly redial the last number dialed. Simply lift the handset and
press
PHONE
. When you hear the dial tone, press
REDIAL
.
PHONE
Indicator
Illustration of front of base
Illustration of handset
Illustration of handset
Illustration of handset