Filter
Top Products
SpectraLink Corporation Configuration and Administration—NetLink e340/i640 Wireless Telephone
Mitel Networks 3300 and SX-200 ICP and 5220 IP Phone emulation
2.2 Quick Start Guide
1. A wireless LAN must be properly configured and operational through the use of
802.11b APs listed on the NetLink Wireless Telephone Access Point Compatibility
matrix.
2. A TFTP Server must be available on the network in order to load the
appropriate software into the NetLink Wireless Telephones. See the License
Management section for detailed instructions for loading software on NetLink
Wireless Telephones.
3. The supported Mitel Networks VoIP solution must be connected to your
network and completely operational.
4. The NetLink SVP Server, which facilitates the QoS on the wireless LAN for the
NetLink Wireless Telephones, must be on the same subnet as the NetLink
Wireless Telephones and have the proper versions of software.
Ensure you have the following versions for the SVP Server:
173 svp100.toc
174 zvmlinux
175 flashfs
5. Visit http://www.spectralink.com/service/software.php to download the latest
NetLink Wireless Telephone and any updates to the NetLink SVP Server
software.
6. Install the correct NetLink Wireless Telephone software and any updates to the
NetLink SVP Server software per Section 5.2 Configuration Process for the NetLink
Wireless Telephones and per NetLink SVP Server Installation, Setup and Maintenance
section 6.1 Software Updates for the NetLink SVP Server. Ensure the software is
properly loaded on the TFTP server.
7. Configure your NetLink Wireless Telephone to ensure that it is associated with
the wireless LAN, has the appropriate software, and has the correct IP address
for the supported Mitel Networks IP telephony system. See the License
Management section and the NetLink Wireless Telephone Configuration section for
detailed instructions for loading software onto and configuring NetLink Wireless
Telephones.
IP multicast addresses are used by the NetLink i640 Wireless Telephone.
This requires that multicasting be enabled on the subnet used for the
NetLink Wireless Telephones and SVP Server.
Routers are typically configured with filters to prevent multicast traffic
from flowing outside of specific domains. The wireless LAN can be placed
on a separate VLAN or subnet to reduce the effects of broadcast and
multicast traffic from devices in other network segments.
PN: 72-1084-02-E.doc Page 6