Filter
Top Products
SpectraLink Corporation Configuration and Administration—NetLink e340/i640 Wireless Telephone
Mitel Networks 3300 and SX-200 ICP and 5220 IP Phone emulation
beacon interval of 200ms. The third has a signal strength of –56dbm, is configured
on channel 11 with a beacon interval of 100ms.
a b 7 b c 8
- 2 8
0 2
1 0 0
2 a e 5 7 8
- 4 8
0 6
2 0 0
2 a e 5 9 6
- 5 6
1 1 1 0 0
A n y
D e t l
When the any ESSID mode is selected, the summary display contains the first six
characters of the APs ESSID instead of the beacon interval as in the example below.
a b 7 b
- 2 8
0 2
A L P H A
2 a e 5
- 4 8
0 6
W S M T E S
2 a e 5
- 5 6
1 1
v o i c e
M y I D
D e t l
In detail mode the display would appear as follows. The Left/Right arrow keys will
move between AP indices.
i : b b b b b b
s n
c h
b c n
e e e e e e e e e e e
D G H I
r r r r r r r r r r r r r + x x x x
m m m
G : g g g g
P : p p p p
A n y
S m r y
Where:
• i = Index of selected AP (value will be from 0 to 3 inclusive)
• bbbbbb = The last three octets of the BSSID for a discovered AP.
• sn = Signal strength in –dbm
• ch = Channel
• bcn = Beacon interval
• eeeeeeeeeee = ESSID (Up to first 11 characters)
• DGHI = Standards supported
• rrrrrrrr = Rates supported. Basic rates will have a “b” following the rate.
• + = more rates are supported than those displayed
• xxxx = WMM or UPSD if those QoS methods are supported
• mmm = Security mode
• G:gggg = Group key security
• P:pppp = Pairwise key security
• Any/MyID = Softkey to toggle between “single ESSID” and “any ESSID”
modes.
• Detl/Smry = Softkey to toggle between the multiple AP display (summary), and
the single AP display (detail).
Numbers racing across the handset display indicate AP information is being
obtained. A
Waiting message indicates the system is not configured properly and the
handset cannot find any APs.
PN: 72-1084-02-E.doc Page 42