Filter
Top Products
6. For models with multiple languages,
select the desired language based
on the setting below.
[ 1 ] - German
[ 2 ] - Spanish
[ 3 ] - French
[ 4 ] - English
Language
selector
INSTALLATION
–
8
–
After mounting the door sensor, it - Please ensure the magnet is aligned with
doesn’t work anymore. the red marking on the transmitter.
- If you are mounting the sensor on to a
metal door or window, a spacer may be
required to avoid magnetic interference
caused by the metal door / window.
- Make sure the sensor is within the operation
range of the control panel by bringing it
closer to the control panel.
My motion sensor is not very The motion sensor is designed to detect the
responsive, sometimes when I walk “First Motion”. First Motion means no motion
by it, the control panel doesn’t respond, is detected within the past 20 seconds,
but sometimes it does. and if a motion is then detected, that is the
“First Motion”. So if you continue to walk
in front of the motion sensor, it will only
pick up the first motion. Unless you wait
for 20 seconds, then walk again, the control
panel will respond. Otherwise, the control
will only respond to the first motion.
TROUBLE SHOOTING
–
45
–
When a sensor is triggered, the - Make sure the battery in the sensor is
control panel doesn’t respond at all, installed properly, pay attention to the
what is the problem? polarity.
- Make sure the sensor is learned to the
control panel. Follow instructions on
page 34 on how to learn a sensor.
- You may try to bring the sensor closer to
the control panel, ensure it is not out of
the operation range.
My motion sensor sometimes gets Ensure the motion sensor is not facing
triggered by itself, how can I prevent direct sunlight, nor any A/C or furnace
that? vents. You may also reduce the sensitivity
to low. If your motion sensor is located
outdoors, you may want to relocate it.
Sensors