Filter
Top Products
Device Quickstart Guide
© Phoneserve. All Rights Reserved Worldwide. info@phoneserve.com
6
PSTN Line Tab:
When you have entered the above values, go to the bottom of the page
and click the “Submit All Changes” button. The SPA will update and
reboot – your web browser should refresh in 5 seconds. If you wish, you
may check each tab to confirm that the new values have been saved.
The SPA will now be ready to make calls.
If you need to reset your SPA3000 to factory settings just enter
73738#
6. Making Phone Calls through the PSTN line:
Call your PSTN Line number.
If you have protected your PSTN line with a PIN, you will hear a
three beep signal, enter your PIN followed by #, otherwise go to
point 3.
When you hear the new dialling tone, enter the phone number you
want to call through Phoneserve.
When you finish your conversation DO NOT forget to hang up by
dialling
**#
to clear your VoIP call.
Line Enable:
Yes
Sip Settings:
Sip Port: 5061
Proxy and Registration:
Proxy: adp1.winnerip.com
Use OB Proxy in Dialog: NO
Register: No
Make call without reg: Yes
Ans call without reg: Yes
Subscriber Information:
User ID: Phoneserve Account Number (18 digits)
VoIP to PSTN Gateway:
VoIP to PSTN Gateway Enable: Yes
PSTN to VoIP Gateway:
PSTN to VoIP Gateway Enable: Yes
PSTN Ring Thru Line 1: No (if you are dedicating your PSTN line to this service)
Yes (if you are sharing the line to receive phone calls)
FXO timer Values:
PSTN Answer delay: 8