Filter
Top Products
Device Quickstart Guide
© Phoneserve. All Rights Reserved Worldwide. info@phoneserve.com
4
4. IVR Code table
Action Command Choices Description
Enter Interactive Voice
Response Menu
**** Use this command to enter the Interactive Voice Response
Menu. Do not press any other keys until you hear
“Configuration menu”. Please enter option followed by the #
(pound) key or hang up to exit
Check DHCP 100 Use this command to find out if DHCP has been enabled or
disabled. If enabled, the Phone Adapter will be assigned an
IP address automatically by your network router or gateway.
If disabled, then the Phone Adapter will use a static IP
address.
Enable/Disable DHCP 101 Enter 1 to enable
Enter 0 to disable
Enable or disable the Phone Adapter’s DHCP feature. If your
network router assigns IP addresses, then enter 1.
Otherwise, enter 0.
Check IP Address 110 You will hear the current IP address of the Phone Adapter
Set Static IP Address 111 Enter the IP address
using numbers on the
telephone keypad.
Use the * (star) key
when entering a
decimal point.
To set a static IP address, the DHCP feature must be
disabled. If the DHCP feature is enabled, then you will hear
“Invalid Option” if you try to set a static IP address.
Check Network Mask
(or Subnet Mask)
120 You will hear the current network mask of the Phone Adapter.
Set Network Mask (or
Subnet Mask)
121 Enter the network
mask using numbers
on the telephone
keypad. Use the *
(star) key when
entering a decimal
point.
To set the network mask, the DHCP feature must be disabled.
If the DHCP feature is enabled, then you will hear “Invalid
Option” if you try to set a static IP address.
Check Static Gateway
IP address
130 You will hear the current Gateway IP address of the Phone
Adapter.
Set Static Gateway IP
address
131 Enter the IP address
using numbers on the
telephone keypad.
Use the * (star) key
when entering a
decimal point.
To set the Static Gateway IP address, the DHCP feature must
be disabled. If the DHCP feature is enabled, then you will
hear “Invalid Option” if you try to set a static IP address.
Check MAC Address 140 You will hear the MAC address of the Phone Adapter in
hexadecimal string format
Check Firmware
Version
150 You will hear the version number of the firmware currently
installed on the Phone Adapter
Enable/Disable Web-
based Utility of Phone
Adapter
7932 Enter 1 to enable
Enter 0 to disable
This feature is often protected by a password only from
Internet Phone Service Provider. If you can’t access it, please
contact your IPSP for more information.
Manual Reboot 732668 After your hear “Option Successful”, hang up the phone. The
Phone Adapter will automatically reboot.
Factory Reset 73738 Enter 1 to confirm
Enter * (star) to
cancel
This feature is often protected by a password only from
Internet Phone Service Provider. If you can’t access it, please
contact your IPSP for more information.
After you have entered your password, the Phone Adapter
will request confirmation. After confirmation, you will hear
“Option Successful”. Hang up the phone. The Phone Adapter
will reboot and all settings will be reset to their factory
settings.