Filter
Top Products
Using the EZX 60
18
Changing the speaker volume
You can only adjust the speaker volume during an active call:
̈ To increase the volume step-by-step, press the volume up button º.
̈ To reduce the volume step-by-step, press the volume down button ¶.
̈ To change the volume continuously, press and hold the respective
volume button.
The speaker volume can be adjusted in 8 steps. The volume is factory
preset to a medium level. When the minimum or maximum volume is
reached, a high or low beep is heard in the headset. When you switch
off the headset, the current volume setting is saved.
Changing the ring tone volume*
You can adjust the ring tone volume while the headset is in standby mode
(no active call):
̈ To increase the volume step-by-step, press the Volume up button º.
̈ To reduce the volume step-by-step, press the Volume down button ¶.
̈ To change the volume continuously, press and hold the respective
volume button.
The ring tone volume can be adjusted in 8 steps. The volume is factory
preset to a medium level. When the minimum or maximum volume is
reached, a high or low beep is heard in the headset. When you switch
off the headset, the current volume setting is saved.
* This function must be supported by the mobile phone.
WARNING Hearing damage due to high volumes!
Listening at high volume levels for long periods can lead to
permanent hearing defects. Please protect your hearing.
Sennheiser headsets also sound exceptionally good at low
volumes.
̈ Set the volume to a medium level.
ᕧ
º
Depending on your mobile phone you can also change the
speaker volume using your mobile phone (see the manual of
the respective mobile phone).
ᕧº