Filter
Top Products
23
Using the headset system
Switching the headset on/off
Switching the headset on
̈ Press and hold the LINK button ብ for 5 seconds.
The HEADSET LED ቤ flashes blue 3 times and the wireless link to the
base station is established (where required). An ascending confirma-
tion beep is heard in the headset.
Switching the headset off
̈ Press and hold the LINK button ብ for 5 seconds.
The HEADSET LED ቤ flashes red 3 times.
Establishing a wireless link between headset and
base
station
To establish a wireless link between headset and base station:
̈ Press the LINK button ብ on the headset.
The link is established. The LINK LED ¿ lights up blue and the
HEADSET LED ቤ flashes blue.
To disconnect a wireless link between headset and base station:
̈ Press the LINK button ብ on the headset.
The link is disconnected. The LINK LED ¿ and the HEADSET LED ቤ go
off.
If you place the headset into the base station, the headset automat-
ically switches to standby mode. In standby mode, the power
consumption is very low and the radiated power is reduced to a
minimum. The HEADSET
LED ቤ lights up blue and the rechargeable
battery is being charged.
4
3
4
3
¿
»
³
You can also establish or disconnect the wireless link by pressing
the PC button
³ or the PHONE button » on the base station
(depending on the selected mode (PC or Phone), see page 28).
If your telephone has a built-in electronic hook switch supporting
the MSH standard (see page
13), you can only disconnect the wire-
less link between headset and base station by placing the headset
into the base station. The control signals (“accept a call”, “end a
call”) of the headset are still transmitted to the electronic hook
switch without.