Filter
Top Products
25
• When you press a button from the keypad, you should hear the confirmation
"beep" from the handset. Try dialling more slowly and ensure you hear beep
sounds. If not try pressing the same number again.
My handset(s) have static noise
• Try re-registering the handset to the main base unit as described in the
manual.
TELEPHONE
No dial tone
Check installation:
- Is the base power cord connected to a working outlet?
- Is the telephone line cord connected to the base unit and the wall jack?
• Disconnect the base from the wall jack and connect another phone to the
same jack. If there is no dial tone in the second phone, the problem might be
your wiring or local service.
• Is the handset out of range of the base?
• Make sure the battery is properly charged (12 continuous hours).
• Is the battery pack installed correctly?
• Did the handset beep when you pressed TALK? Did the CHARGE/IN USE
indicator come on? The battery may need to be charged.
Dial tone is OK, but cannot dial out
• Make sure the TONE/PULSE dialing mode is set to TONE or PULSE
according to your phone service.
Handset does not ring
• Make sure the RINGER switch on the handset is turned to ON.
• You may have too many extension phones on your line. Try unplugging
some phones.
• See solutions for No dial tone.
You experience static, noise, or fading in and out
• Change channels.
• Is handset out of range? Move closer to the base.
TROUBLESHOOTING
sy5822 10 april.p65 2006/5/12, ¤U¤È 02:5225