Sanyo CLT-A5822 Cordless Telephone User Manual


 
10
Before using this telephone, 4 initial settings must be completed on the handset:
Language, Area code (this is required to use Caller ID service from your tele-
phone company), Ringer tone, and Tone/Pulse setting.
Language setting
1. Make sure the phone is OFF (not in TALK mode).
2. Press FLASH/PROG until “ 1 ENG 2 FRA 3 ESP shows on screen.
3. Press CID/VOL
or , or the number keys (1 – 3) to select the desired
language.
4. Press FLASH/PROG to store selection. You will hear a confirmation tone.
Area code setting
For proper Caller ID operation, you must program your area code.
1. Make sure the phone is OFF (not in TALK mode).
2. Press FLASH/PROG repeatedly until “AREA CODE - - - ” shows on screen.
3. Enter your 3-digit area code using the number keys. To change a digit, press
CH/DEL and then re-enter the number.
4. Press FLASH/PROG to store selection. You will hear a confirmation tone.
Ringer tone
1. Make sure the phone is OFF (not in TALK mode).
2. Press FLASH/PROG repeatedly until “RINGER TONE 1” shows on screen.
3. Press CID/VOL
or , or press the number keys 1-3 to select the desired
ringer tone.
4. Press FLASH/PROG to store selection. You will hear a confirmation tone.
Tone/pulse setting
1. Make sure the phone is off (not in TALK mode).
2. Press FLASH/PROG repeatedly until “ 1TONE 2 PULSE ” shows on
screen.
3. Press CID/VOL
or , or press the number keys 1-2 to select TONE or
PULSE.
4. Press FLASH/PROG to store selection. You will hear a confirmation tone.
INITIAL PROGRAMMING
sy5822 10 april.p65 2006/5/12, ¤U¤È 02:5210