Filter
Top Products
TOP
3/16 in.
3-15/16 in.
(4.8 mm)
(100 mm)
E8
Direct wall-mounting
If you do not have a standard wall plate, you can still mount your phone directly to the
wall. Before doing this, consider the following:
• Avoid electrical cables, pipes, or other items behind the mounting location, that could
cause a hazard when inserting screws into the wall.
• Try to mount your phone within 10 –15 feet (3 – 4.5 m) of a working phone jack to
avoid excessive cord lengths.
• Make sure the wall material is capable of supporting the weight of the base and
handset.
• Use
#10 screws with anchoring devices suitable for the wall material where the base
unit will be placed.
1
Insert two mounting screws with a minimum length
of 1-3/8 inches (35.5 mm) into the wall, 3-15/16
inches (100 mm) apart. Allow about 3/16 of an
inch (4.8 mm) between the wall and screwheads
for mounting the phone.
2
Refer to steps 1 through 9 on pages E7 and E8 to
mount the telephone.
8
On the base unit, pull the handset retainer out
of the slot. Rotate it clockwise 180 degrees.
9
Flip the retainer. Slide it back into the slot so
that the lip of the retainer is up and the
points down. The retainer holds the handset in
place.
Handset retainer
When the phone is mounted on
the wall, the handset belt clip
must be attached to hold the
handset in the charging position.
Do not place the handset with the
display facing inside.
Note:
GETTING
STARTED
CLT2430 5th 8/9 8/10/00 4:28 PM Page 12