Filter
Top Products
12
RECALL DIAL TONE
Press the NEW button to disconnect your existing call,wait for dial tone and then
make a new call on the same line.
NOTE: If this button does not appear on your keyset, the FLASH button may be
programmed to recall dial tone.
SENDING A FLASH
While on an outside call,press the FLASH button to send a flash to the telephone
company.This is required for some custom calling features or CENTREX use.
NOTE:Flash is not available on an ISDN circuit.
BUSY LINE QUEUING WITH CALLBACK
If you receive a busy signal when you are selecting an outside line,this means that
the line or group of lines is busy.
• Press the CBK button, if programmed, or dial 44. You will hear confirmation
tone.
• When the line becomes free,the system will call you back.
• Lift the handset or press the SEND button to answer,wait for dial tone and dial
the telephone number or speed dial number again.
NOTES:
1. A callback will be canceled if not answered within 30 seconds.If you have set
a callback,your CBK button will light.
2. If the Hot Keypad feature has been turned off, you must first lift the handset
or press the SPEAKER button before dialing.
CANCELING CALLBACK
A callback will be canceled if not answered within 30 seconds. If you have set a
callback,your CBK button will light.
Your phone may have a maximum of five callbacks to lines and/or stations set at a
time.To cancel a callback:
• Press the CBK button, if programmed, or dial 44. You will hear confirmation
tone.
• While you are listening to confirmation tone,press the HOLD button.This will
cancel the oldest set callback.
NOTE: If the hot keypad feature is turned off,you must first lift the handset or press
the SPEAKER button before dialing.
ds_phones.qxp 5/27/2009 3:55 PM Page 18