Filter
Top Products
18
PROGRAM SYSTEM SPEED DIAL NUMBERS
The system list starts with 200 numbers and can be increased in blocks of ten.The
system may have either 500 or 950 maximum depending on the setting in MMC
861.See your service company to increase or decrease the system list.
The speed dial codes are 500
–999 or 050–999.Each speed dial number consists of
a line access code and the telephone number to be dialed.The access code can be
any line group,individual line,station group or individual extension.The speed dial
number can be up to 24 characters long including ✱,#, FLASH and PAUSE.
NOTE: If Least Cost Routing (LCR) is being used, the LCR access code must be
entered.
When you are entering a speed dial number,there are some special keys that you
will need to use.These are the bottom row of programmable keys on the keysets
and are known as keys A, B, C,D, E and F.
PROGRAM KEYS
UP & DOWN - Select the speed dial bin.
KEYPAD - Used to enter number.
HOLD - Press to clear entry.
SPK/RLS - Save data and advance to next program.
A - Does not have a function.
B - Inserts a FLASH.
C - Inserts a PAUSE.
D - Changes the dialing type from pulse to tone.
E - Hides and displays digits.
F - Changes display to speed dial name entry.
DCS
KEYSETS [NOT SUPPORTED ON OFFICESERV 7100]
A
B
C
D E
F
12 BUTTON KEYSET
PROGRAMMABLE KEYS LAYOUT
A
B C
D
E F
24 BUTTON KEYSET
PROGRAMMABLE KEYS LAYOUT
System_Administration_Guide.qxp 4/30/2007 12:56 PM Page 25