Filter
Top Products
4. Press TRSF to store and exit
programming OR press SPK to store
and advance to the next program
NOTE: Directory information is always 11 characters.
DEFAULT DATA: NONE
Names are written using the keypad. Each press of a key will select a character.
Pressing the dial pad key moves the cursor to the next position.For example,if the
directory name is “SAM SMITH,”press the number “7” three times to get the letter
“S.” Press the number “2” once to get the letter “A.” Continue selecting characters
from the table below to complete your message. Press the “A” key to change the
letter from upper case to lower case.
NOTE:When the character you want appears on the same dial pad key as does the
previous character,press the UP key to move the cursor to the right.
DCS
KEYSETS [NOT SUPPORTED ON THE OFFICESERV 7100]
COUNT 1 2 3 4 5
DIAL 0 Q Z . ) 0
DIAL 1 space ? , ! 1
DIAL 2 A B C @ 2
DIAL 3 D E F # 3
DIAL 4 G H I $ 4
DIAL 5 J K L % 5
DIAL 6 M N O ^ 6
DIAL 7 P R S & 7
DIAL 8 T U V Q 8
DIAL 9 W X Y ( 9
DIAL ✱ := [ ] ✱
The # key can be used for the following special characters:#, space, &, !,:, ?, .,%, $, -
, /,=, [, ],@, ^, (, ),_, +, {, },|, ;, \,“ and ~.
14
System_Administration_Guide.qxp 4/30/2007 12:56 PM Page 21