Filter
Top Products
12
DISABLING THE LINE 2
INDICATOR
If you have only one telephone line, the
LINE 2 indicator lights and LINE 2 EX-
TENSION appears on the display. Follow
these steps to disable the LINE 2 indica-
tor.
1. Press
REVIEW
8 or 9 repeatedly
until the call total appears.
2. Press
REVIEW
9 until LINE 2 EN-
ABLED appears (about 3 seconds).
3. Press
REVIEW
8 or 9. LINE 2
DISABLED appears.
4. Press
DELETE
to return to the cur-
rent time display.
ADJUSTING THE DISPLAY
CONTRAST
1. Press
REVIEW
8#or 9 repeated-
ly until the call total appears.
2. Press and hold down
REVIEW
8
for about 3 seconds until CONTRAST
X appears.
3. Within 30 seconds, repeatedly press
REVIEW
8 or 9 to adjust the dis-
play’s contrast from 1 to 8.
Notes:
• If CONTRAST X disappears before
you press
REVIEW
8 or#9, re-
peat Steps 1–3.
• If you did not connect an AC
adapter, you can only adjust the
display contrast from 1 to 3, and
only after you pick up the hand-
set.
4. When you finish adjusting the con-
trast, press
DELETE
to return to the
main display.
SETTING THE RINGER
VOLUME
To set the ringer’s volume for LINE 1 or
LINE 2, set the correlating
L1
RINGER
or
L2
RINGER
to
HIGH
,
LOW
, or
OFF
.
Note:
You can still answer calls if you
hear an extension phone ringing, and
you can still make calls.
SETTING THE DIALING
MODE
Set
TONE
/
PULSE
for the type of service
you have, tone or pulse. If you are not
sure which type you have, do this test.
1. Set
TONE
/
PULSE
to
TONE
.
2. Pick up the handset and listen for a
dial tone.
43-935.fm Page 12 Friday, January 14, 2000 3:07 PM