Filter
Top Products
26
TROUBLESHOOTING
We do not expect you to have any problems with your TAD-733, but if you do, the fol-
lowing suggestions might help.
If you still have problems, disconnect the phone. If other phones on the same line
work properly, the fault is in this phone or its installation. If you cannot find the prob-
lem, take your TAD-733 to your local RadioShack store for assistance.
Problem Suggestion
Noise, static, or weak signal. Move the handset closer to the base or relocate the
base (see “Selecting a Location” on Page 7).
Make sure the base’s antenna is vertically upright
and the handset’s antenna is properly connected.
TAD does not answer calls. Make sure the TAD is set to answer calls.
Check all phone line connections.
Make sure the AC adapter is properly connected.
TAD does not record callers’
messages.
Memory may be full (
FL appears). Delete some
messages.
Turn off the announce-only feature (see “Screening
Calls” on Page 20).
The handset does not ring
when you receive a call.
Make sure the ringer is turned on.
Return the handset to the base for about 5 seconds
to reset the security access-protection code.
Make sure the battery pack is properly connected
and charged.
You hear other calls while us-
ing your phone.
Try another phone connected to the same line. If
you still hear other calls, the problem is probably in
your wiring or local service. Contact your local tele-
phone company.
There is no dial tone. Check all phone line connections.
Make sure the AC adapter is properly connected.
Make sure the battery pack is properly connected
and charged. If the battery pack will not charge, re-
place it (see “Replacing the Battery Pack” on
Page 28).
43-733.fm Page 26 Friday, September 17, 1999 8:57 AM