Filter
Top Products
9
5. Plug the adapter into a standard AC
outlet.
6. Lift the base’s antenna to a vertical
position.
On a Wall Plate or Wall
1. Insert the two tabs at the top of the
narrow end of the supplied bracket
into the base’s upper tab slots as
shown, then press down on the
bracket’s latches and insert them in-
to the lower slots.
2. Plug one end of the supplied short
modular cord into the
TEL LINE
jack
on the back of the base as in “On a
Desk Top,” Step 1, on Page 8.
3. Insert the supplied AC adapter’s
barrel plug into the
DC IN 9V
jack as
in “On a Desk Top,” Step 3, on Page
8.
4. Route the adapter and modular
cords through the grooves on the
bracket.
5. Plug the modular cord’s other end
into the wall plate jack, then align
the bracket’s keyhole slots with the
wall plate studs and slide the base
downward to secure it.
6. Plug the adapter into a standard AC
outlet.
7. Press and lift out the handset hold-
er, flip it over as shown, then snap it
back into place so it holds the hand-
set.
43-725.fm Page 9 Tuesday, February 23, 1999 2:47 PM