Filter
Top Products
28
If you still have problems, disconnect the TAD-725. If other phones on the same line
work properly, the fault is in this phone or its installation. If you cannot find the prob-
lem, take your phone to your local RadioShack store for assistance.
The handset does not ring or
receive a page.
Move the base away from other electrical
devices and sources of noise.
The handset stops working or
works poorly during a call.
Move the handset closer to the base.
Lift the base’s antenna to a vertical position.
Be sure the battery pack is charged. (If the bat-
tery power is too low, it does not have enough
power to light the display.)
If the base loses power while the handset is
away, the security access-protection code might
change. Restore power to the base, then place
the handset back on the base. The CHARGE/IN
USE indicator lights, indicating that the code is
set again.
Check the charging contacts on the handset and
base. If they are dirty, clean them with a pencil
eraser.
The TAD does not answer
calls.
Make sure the TAD is turned on.
Make sure the AC adapter is properly con-
nected.
Check all phone line connections.
The TAD does not record call-
ers’ messages.
REC TIME
is set to
ANN
(announcement only).
Set it to
1
or
4
.
Delete messages if memory is full.
The TALK/BATT indicator
flashes slowly when it is on the
base and/or the CHARGE/IN
USE indicator flashes every few
seconds.
Be sure the battery pack is correctly connected.
Problem Suggestion
43-725.fm Page 28 Tuesday, February 23, 1999 2:47 PM