Filter
Top Products
21
TAD OPERATION
SELECTING THE
OUTGOING MESSAGE
The TAD has two prerecorded outgo-
ing messages. One asks the caller to
leave a message: “Hello, no one is
available to take your call. Please
leave a message after the tone.” The
TAD uses this message when
REC
TIME
is set to
1
or
4
(see “Setting the
Record Time”).
The other is simply an announcement
and does not let the caller leave a
message: “Hello, no one is available
to take your call.” The TAD uses this
message when
REC TIME
is set to
ANN
(announcement only).
You can also record your own mes-
sage (see “Recording/Deleting an
Outgoing Message”). When you
record your own outgoing message,
the TAD uses it for all
REC TIME
set-
tings.
To switch between your outgoing
message and the TAD’s prerecorded
message, press
OGM
. When the cur-
rent message begins to play, press
OGM
again. The TAD switches to the
other message and plays it.
RECORDING/DELETING
AN OUTGOING
MESSAGE
To record your outgoing message (up
to 30 seconds long), hold down
OGM
until the TAD beeps and -- appears.
When you finish your message, press
PLAY/STOP
. The TAD plays back your
message.
To delete your outgoing message and
use the TAD’s prerecorded messag-
es, hold down
OGM
until the TAD
beeps. Then press
OGM
again within
two seconds.
SETTING THE RECORD
TIME
Set
REC
TIME
to
1
,
4
, or
ANN
to deter-
mine how the TAD-725 will record in-
coming messages.
1
— The TAD plays the outgoing
message and lets callers leave a
message up to 1 minute long.
4
— The TAD plays the outgoing
message and lets callers leave a
message up to 4 minutes long.
ANN
(announcement only) — The
TAD plays the outgoing message
but does not let callers leave a
message.
REC TIME
OGM
43-725.fm Page 21 Tuesday, February 23, 1999 2:47 PM