Filter
Top Products
10
8. Lift the base’s antenna to a vertical
position.
Note:
To mount the TAD directly on a
wall, you need two screws (not supplied)
with heads that fit into the keyhole slots
on the bottom of the base.
Follow the steps under “On a Wall Plate
or Wall” on Page 9, then apply these ad-
ditional instructions for placement on a
wall.
1. Drill two holes 3
5
/
16
inches (100 mm) apart.
Then thread a screw
into each hole, letting
the heads extend
about
5
/
16
inch (8 mm)
from the wall.
2. Plug one end of the supplied long
modular cord into the TEL LINE jack
at the back of the base.
3. Align the bracket’s keyhole slots
with the mounting screws and slide
the base downward to secure it.
100
8
CONNECTING AND
CHARGING THE BATTERY
PACK
The TAD-725 comes with a recharge-
able nickel-cadmium battery pack in-
stalled in the handset, but not
connected. Before using your phone,
you must connect the battery pack, then
charge it for about 24 hours.
1. Press down and slide off the battery
pack compartment cover.
2. Unfasten the plastic retainer strap
and lift the battery pack out of the
compartment. Plug the battery
pack’s connector into the socket in
the compartment. The connector fits
only one way.
3. Put the battery pack in the compart-
ment and fasten the retainer strap.
4. Replace the cover.
43-725.fm Page 10 Tuesday, February 23, 1999 2:47 PM