Filter
Top Products
30
PROBLEM SOLVING
We do not expect you to have any problems with your TAD-1006, but if you do, try
these suggestions. If the TAD-1006 still does not operate as you think it should,
take it to your local Radio Shack store for assistance.
Problem Cause Remed
y
The TAD records a dial
tone, siren, beeping, or
an operator’s voice
instead of the caller’s
message.
The caller hung up without
leaving a message or without
using the maximum time, and
your local telephone com-
pany does not send out CPC
signals.
Press
NEXT
(or 9
remotely) to play the
next message.
The TAD does not
answer calls.
The phone line is not properly
connected.
Check all phone line
connections.
The TAD is not plugged into
power.
Make sure the AC
adapter is properly
connected to the
TAD and to power.
The TAD is not set to answer
calls.
Press
ON/OFF
so the
ANSWER indicator
turns on.
The outgoing
announcement
is distorted.
You were too close to the TAD
or you spoke too loudly when
recording the announcement.
Re-record the
announcement,
speaking in a normal
tone of voice about
12 inches from the
TAD.
There was too much back-
ground noise in the room
when you recorded the
announcement.
Re-record the
announcement.
The TAD does not play
the outgoing
announcement you
recorded.
The outgoing announcement
is less than 2 seconds long.
Record a new outgo-
ing announcement
that is at least 2 sec-
onds, but no more
than 1 minute long.
43-768.fm Page 30 Friday, August 13, 1999 2:49 PM