Filter
Top Products
17
2. Press
1/TIME
. The TAD says,
“
Press one for Monday, two for
Tuesday, three for Wednesday,
four for Thursday, five for Friday,
six for Saturday, seven for Sun-
day.
”
3. Press a number button to set the
day of the week. The TAD says
the day of week and, “
Enter the
time.”
4. Press two digits for the hour. The
TAD says the hour.
Note
: If you make an invalid entry
(for example, 00 or 13), the TAD
beeps three times and repeats,
“
Enter the time.”
5. Press two digits for the minute.
The TAD says the minute and,
“
Press one for AM, two for PM.”
Note
: If you make an invalid entry
(for example, 66), the TAD does
not respond. Make a correct entry
within 7 seconds.
6. Press
1
or
2
. The TAD says, “
AM
”
or, “
PM
,” then the current day and
time.
To hear the current day of the week
and time at any time, press
1/TIME
.
SETTING THE NUMBER
OF RINGS
The TAD is preset to sound four rings
before it answers the first call. Follow
these steps to change the number of
rings (from 1-9).
Notes
:
• If you plan to check your mes-
sages by long distance, be sure
the number of rings is set to at
least three to avoid unnecessary
long distance charges when you
call to check your messages (see
“Using the Toll-Saver” on
Page 26).
• In Steps 2 and 3, you must enter
your selection within 7 seconds.
Otherwise, the TAD beeps three
times then exits the programming
mode. If this happens, start over
again at Step 1.
1. Press
DELETE/PROG
. The TAD
beeps once.
2. Press
3/RING
. The TAD beeps
once.
3. Enter the desired number of rings
(up to 9) using the small keypad
on the TAD. The TAD repeats the
number, then beeps twice.
illustration
illustration
43-768.fm Page 17 Friday, August 13, 1999 2:49 PM