Filter
Top Products
16
TAD PREPARATION
Complete the procedures in this sec-
tion before you begin using the TAD to
answer calls.
Notes
:
• The keypad is located under the
cover on the front of the TAD-
1006. Lift the cover to access the
keys.
• Before you begin any of the pro-
cedures in this section, be sure
the TAD is turned on (see “Turning
the TAD On/Off”).
TURNING THE TAD
ON/OFF
To turn on the TAD, press
ON/OFF
so
the ANSWER indicator turns on.
To turn off the TAD, press
ON/OFF
again so the ANSWER indicator turns
off.
Notes
:
• Once you turn on the TAD, it is set
to answer calls (see “Setting the
TAD to Answer/Not Answer Calls”
on Page 20).
• You can also turn on the TAD
remotely (see “Remote Answer-
On” on Page 27).
SETTING THE DAY
AND TIME
You must set the current day and time
so the TAD will record the day and
time on each incoming message,
memo, and 2-way conversation it
records.
Note
: In Steps 2-6, you must enter
your selection within 7 seconds after
the TAD finishes saying the instruc-
tion. Otherwise, the TAD beeps three
times then exits the program mode. If
this happens, start over again at
Step 1.
1. Press
DELETE/PROG
. The TAD
beeps once.
illustration
illustration
illustration
43-768.fm Page 16 Friday, August 13, 1999 2:49 PM