Filter
Top Products
23
Problem Cause Remedy
The TAD does not
respond to remote
commands.
You entered an incorrect
remote security code.
Carefully re-enter
your remote security
code. If the TAD fails
to respond, the secu-
rity code might have
reset to the default
code. Enter the de-
fault remote security
code (00).
AC power failure. Make sure that AC
power is restored and
the
9V DC
adapter is
properly connected to
the TAD and the AC
outlet.
The TAD sounds three
short beeps when you
access it by remote.
The OGM is too short to
allow remote access.
Record a new OGM at
least 2 seconds long.
The TAD’s memory is full. Erase messages from
the TAD.
43-745.fm Page 23 Friday, August 13, 1999 2:16 PM