Filter
Top Products
8
5. Plug the short modular cord into
the wall plate jack, press the ex-
cess cord into the slot in the cen-
ter of the base, then align the
base’s keyhole slots with the wall
plate studs and slide the base
downward to secure it.
6. Press and lift out the handset
holder, turn it over and rotate it
180°, then snap it back into place
so it holds the handset.
7. Plug the adapter into a standard
AC outlet. The POWER indicator
on the base lights.
8. Lift the base’s antenna to a verti-
cal position.
Slot for
Excess
Cord
Mounting the Base Directly
on the Wall
For this mounting method, you need
two flat-head wood screws (not sup-
plied) with heads that fit into the key-
hole slots on the bottom of the base.
1. Drill two holes 3
5
/
16
inches apart. Then
thread a screw into
each hole, letting the
heads extend about
3
/
16
inch from the
wall.
2. Plug one end of the supplied long
modular cord into the
TEL LINE
jack on the back of the base.
3. Route the modular cord through
the upper and lower grooves on
the bottom of the base.
3
/
16
3
5
/
16
Upper
Groove
Lower
Groove
43-1095.fm Page 8 Tuesday, August 17, 1999 3:37 PM