Filter
Top Products
11
• When you first use the phone after
charging or recharging the battery
pack, the phone might not work
and you might hear an error tone.
If this happens, return the handset
to the base for a few seconds.
• If the battery pack loses its charge
completely or the base loses pow-
er while the handset is away from
it, the security access-protection
code needs to be reset. To reset
the security code, place the hand-
set on the base. If it was the hand-
set that lost power, leave the
handset on the base to charge the
battery pack.
• About once a month, fully dis-
charge the battery pack by keep-
ing the handset off the base until
the TALK/BATT LOW indicator
flashes. Otherwise, the battery
pack loses its ability to fully re-
charge.
• If the TALK/BATT LOW indicator
does not light and the phone does
not work, recharge the battery
pack. (The battery power might be
too low to light the indicator.)
• The supplied battery pack should
last for about a year. When the
battery pack loses its ability to ful-
ly recharge, order a replacement
battery pack from your local Ra-
dioShack store (see “Replacing
the Battery Pack” on Page 23).
SETTING THE DIALING
MODE
Set
DIAL MODE
on the back of the base
for the type of service you have. If you
are not sure which type you have, do
this test.
1. Set
DIAL MODE
to
T
.
2. Press
SPEAKER
and listen for a
dial tone from the speakerphone.
The IN USE indicator turns on.
3. Press any number other than
0
.
Note:
If your phone system re-
quires that you dial an access
code (
9
, for example) before you
dial an outside number, do not
press the access code either.
If the dial tone stops, you have
touch-tone service. Leave
DIAL
MODE
set to
T
.
If the dial tone continues, you
have pulse service. Set
DIAL
MODE
to
P
.
4. Press
SPEAKER
again. The IN
USE indicator turns off.
43-1095.fm Page 11 Tuesday, August 17, 1999 3:37 PM