Filter
Top Products
13
SETTING THE DIALING
MODE
Set
DIAL MODE
on the back of the base
for the type of service you have (tone or
pulse). If you are not sure which type
you have, once the battery pack is fully
charged, do this test.
1. Set
DIAL MODE
to
T
(tone).
2. Press
LINE 1
on the base. The line 1
indicator lights.
3. Press any number other than
0
.
Note:
If your phone system requires
that you dial an access code (9, for
example) before you dial an outside
number, do not press the access code
number either.
If the dial tone stops, that line has
tone service.
If the dial tone continues, that line
has pulse service.
4. Press
LINE 1
to release the line,
then repeat the test for Line 2.
If you have tone service on both lines,
leave
DIAL MODE
set to
T
(tone).
If you have pulse service on either line,
set
DIAL MODE
to
P
(pulse).
SETTING THE RINGERS’
VOLUM E
At any time except during a call, press t
or s to set the handset’s ringer volume.
The phone rings at the selected volume.
To set the base’s ringer volume, set
RING VOL
on the back of the base to
OFF
,
LO
, or
HI
.
43-687.fm Page 13 Friday, August 13, 1999 11:12 AM