Filter
Top Products
7
Placing the Base
on a Desk Top
Follow these steps when you place
the base on a desk, shelf, or table.
1. If you have a single 2-line modular
jack, plug one end of the supplied
modular cord into the
TEL LINE 1/2
jack.
Note:
When you make this con-
nection, you should not connect
another modular cord to the
TEL
LINE 2
jack or phone operation will
be erratic.
If you have two separate 1-line
modular jacks, plug one end of the
supplied modular cord into the
TEL LINE 1/2
jack and plug an-
other modular cord (not supplied)
into the
TEL LINE 2
jack.
If you have only a single 1-line
modular jack, plug one end of the
supplied modular cord into the
TEL LINE 1/2
jack to use line 1, or
into the
TEL LINE 2
jack to use
line 2.
2. Plug the supplied AC adapter’s
barrel plug into the
DC IN 9V
jack.
3. Route the adapter’s cord through
the strain relief slot.
4. Plug the adapter into a standard
AC outlet. The POWER indicator
on the base lights.
Strain Relief Slot
43-698a.fm Page 7 Friday, August 13, 1999 12:56 PM