Filter
Top Products
14
SETTING THE DIALING
MODE
Set
P
• •
T
on the back of the base for
the type of service you have. If you
are not sure which type you have, do
this test.
1. Set
P
• •
T
to
T
(tone).
2. Press
SPEAKER
then press
LINE 1
and listen for the dial tone.
3. Press any number other than
0
.
Note:
If your phone system re-
quires that you dial an access
code (9, for example) before you
dial an outside number, do not
press the access code either.
If the dial tone stops, that line has
tone service.
If the dial tone continues, that line
has pulse service.
4. Press
LINE 2
, listen for the dial
tone, and repeat Step 3.
If you have tone service on both lines,
leave
P
• •
T
set to
T
.
If you have pulse service on either line,
set
P
• •
T
to
P
(pulse).
TURNING THE RINGER
ON/OFF
You can turn the ringer on the base on
or off. Set
RINGER
on the back of the
base to the position you want.
The switch setting affects the ringer on
the base only. The handset’s ringer is
always turned on as long as the hand-
set is off the base. When you place the
handset
on
the base and set
RINGER
to
OFF
, the ET-598 does not ring when
it receives a call. However, other
phones connected to the same phone
line still ring.
43-698a.fm Page 14 Friday, August 13, 1999 12:56 PM